Renewable EnergyWind Energy

Wind Turbine Power Curve: Air-Density Correction and a Simple AEP Estimate

Quick answer: a wind-turbine power curve maps hub-height wind speed to electrical power under defined test conditions. Annual energy production (AEP) is obtained by multiplying each wind-speed bin’s expected hours by its power-curve output, then subtracting justified losses. Average wind speed alone is not enough.

Four regions of the curve

  • Below cut-in: the turbine normally produces no power.
  • Partial load: output rises rapidly with wind speed.
  • Rated region: control limits output near nameplate power.
  • Above cut-out: the turbine stops to protect equipment.

The cubic wind-power relationship explains the strong partial-load sensitivity, but actual turbine output follows aerodynamic control, generator limits and the certified curve—not a simple cube at every speed.

Air-density correction

Available wind power is proportional to air density. Density changes with pressure, temperature and humidity. A screening equivalent wind speed can be written:

vequiv = v × (ρ/ρref)1/3

At ρ = 1.10 kg/m³, reference density 1.225 kg/m³ and measured speed 8.0 m/s, equivalent speed is about 7.72 m/s. In the steep part of the curve, that difference can materially change predicted power. Use the turbine/test standard’s required correction method for contractual work.

Worked binned AEP estimate

Wind bin Hours/year Power Energy
5 m/s 1,800 0.25 MW 450 MWh
7 m/s 2,200 0.90 MW 1,980 MWh
9 m/s 1,700 2.10 MW 3,570 MWh
11 m/s 1,000 3.50 MW 3,500 MWh
Rated region 500 4.00 MW 2,000 MWh

Gross energy for these represented bins is 11,500 MWh. If combined wake, electrical, availability, curtailment and environmental losses are independently estimated at 12%, net AEP is 10,120 MWh. Capacity factor is 10,120/(4 MW × 8,760 h)=28.9%.

Do not combine losses blindly

Several losses overlap. A shutdown hour should not be counted again as low power-curve performance. Build a loss tree with clear boundaries: wake, electrical, turbine availability, balance-of-plant availability, curtailment, icing/soiling, high-wind hysteresis and environmental restrictions.

Data-quality checklist

  • Wind speed is corrected to hub height and aligned with turbine sectors.
  • Air density uses measured pressure and temperature where available.
  • Wake and terrain sectors are identified.
  • Power data exclude curtailment and downtime for curve validation.
  • Anemometer calibration and nacelle transfer function are documented.
  • Uncertainty is reported, not hidden in one conservative loss factor.

FAQ

Can I scale power directly by density?

It is a screening shortcut only. Modern turbine control and rated-power limits make the relationship condition-dependent.

Is capacity factor the same as availability?

No. Availability measures readiness or operating time; capacity factor compares actual energy with continuous nameplate production.

Does a higher hub height always increase AEP?

Often, but shear, turbulence, wakes, loads, cost and permitting must all be evaluated.

Read capacity factor versus availability and small-wind site assessment in Europe. Reference: NREL Annual Technology Baseline. Photo: Remigiusz Dettlaff via Unsplash.

Related Articles