Buck Converter Inductor Sizing: Ripple Current, Saturation and Losses

Quick answer: choose the buck inductor from input voltage, output voltage, switching frequency and the permitted ripple current. Then verify saturation current, RMS current, copper loss, core loss and thermal rise. The inductance value alone is not enough.
Ripple-current equation
For an ideal buck converter, duty ratio is approximately D = Vout / Vin. Inductor ripple is ΔIL = (Vin − Vout) × D / (L × fs). Designers often begin with ripple equal to 20–40% of full-load output current. Lower ripple reduces capacitor stress but requires a larger inductor and may slow transient response.
Worked example
Consider 24 V input, 12 V output, 5 A load and 200 kHz switching. Selecting 30% ripple gives ΔIL = 1.5 A. Duty ratio is 0.5, so L = (24 − 12) × 0.5 / (1.5 × 200,000) = 20 µH. A nearby standard value such as 22 µH is a sensible starting point.
Peak and RMS current
Peak current is Iout + ΔIL/2, or 5.75 A in the example. The inductor’s saturation rating needs margin above the worst-case peak, including startup, current-limit tolerance and high-temperature reduction. RMS current is approximately sqrt(Iout² + ΔIL²/12), which determines copper heating.
Do not confuse the current ratings
Manufacturers may specify saturation current at a 10%, 20% or 30% inductance drop, while the temperature-rise current may be based on a 20°C, 40°C or other rise. Read the test conditions. For hot enclosures in Gulf installations, derate both saturation and thermal current using the manufacturer’s curves.
Loss and thermal checks
Copper loss is Irms² × DCR. Core loss depends on flux swing, frequency, core material and temperature; use the vendor’s loss tool or curves. Measure the final temperature in the real PCB because nearby MOSFETs and restricted airflow can dominate the result.
Selection checklist
- Inductance tolerance at operating current
- Saturation current at maximum temperature
- RMS/temperature-rise current
- DCR and core-loss data
- Shielding and EMI requirements
- Footprint, height and assembly limits
FAQ
Is a higher inductance always better? No. It can enlarge the component, raise DCR and reduce transient speed.
Why does measured ripple differ from the equation? Real duty ratio, switching delays, input ripple, capacitor ESR and inductance tolerance all contribute.
See more in Electronics and Electrical Circuits.
Featured photo: Erinada Valpurgieva via Unsplash.



